Most of today was spent in the Garage, building up the gearbox and starting on the engine. Started with the gearbox, and specifically the reverse gear, with the issues I’ave been having with it jumping out of gear. With the gear fitted on it’s shaft, and the selector fitted, I could see that the gear was hitting the back of the case, without the select detent spring lining up. Comparing the original gear and the replacement, I could see that the selector groove was in a different place. So I will be putting the original back in (the new one has badly damaged teeth as a result of jumping out of gear).
This didn’f fully cure the issue, so I measured the selectors as well. Looks like the new selector is too long, putting the gear too far back in the box. This also explains why the box is noisy in second, as the reverse idler was being engaged while selecting second. So back to the original parts there… Beyond this, the box was built up as per the Land Rover manual. And ready to be fitted to the gearbox tomorrow.
Also I managed to hone the bores of the new block to clean the rust marks off, and allow the new piston rings to bed in properly. I did make a start on stripping the parts out of another block, in order to use the crank and rods (with new pistons). However I needed to order new main bearings (only the big end bearings had been replaced), and I was unable to press the gudgeon pins from the pistons, so these will need taking to a machine shop to be sorted
New and old reverse selectors. Replacement is on the right. Spaced at 1.5 inches
And at the gear end, only 1.25 spacing. Replacement selector putting the gear about 1/4″ too far back in the case
Mainshaft back in the casing
And gearbox all built up.
Slight surface rust on the bores of the new block
And all nice and clean after honing.





