Land Rover Gearbox Rebuild (again)

I’ve now finished rebuilding the gearbox again – and probably not for the last time… This time (as there’s no rush to get back on the road with the pandemic) I’ve given the main castings a few coats of duck egg blue paint to match the engine and make it easier to keep clean. I […]

A minor engine rebuild

A week ago I finally decided to pull the heads off of the land rover engine, to see what if I could find out why I was having issues with loosing water & overheating. This is what I found: The head gaskets had broken up somewhat, the worst part being at the back of cylinder […]

Changing a Diff (Fail!)

So I thought I’d spend the evening taking the rear diff out of the landy, so I can change to a 3.54 ratio. Had no issues removing the easy bits, but had no luck getting the differential out of the casing. I even made a diff spreader, but that ended up looking a bit banana-shaped… […]

Land Rover Camper Conversion Update

I have been making some progress on converting the Land Rover into a camper, including starting the new floor (having to lift it up, to make room for the LPG tanks), finishing the storage/seat units on each wheelbox, and making a centre cubby box. Photos save me typing lots! Floor cut away, plus the bracing […]

Land Rover Rebuild – Day 12

Unfortunately I’ve been too carried away to take photos, however the Landy is now running again! Did have a couple of minor issues, like a leaking water pump (just as well I bought a spare!) Now time to do some miles and run the engine in (I’m off to the Netherlands for a long weekend […]

Land Rover Rebuild – Day 10

Got a bit further with the engine rebuild today. Pistons and camshaft fitted, along with fitting the overdrive and new transfer box cover plate. Engine now on its mounts All the pistons fitted And from another angle Transfer box cover plate and overdrive Overdrive Fitted! With the lever fitted (Now there are four gearsticks!)

Land Rover Rebuild – Day 9

Managed to fit the crank, flywheel and engine block today. Had to fit the flywheel to the crank, get that lined up on the gearbox input shaft, then lowered the block (with the bearing shells fitted) onto the crank, then bolted up the main bearings. (Without a crane, I couldn’t build the engine, then fit […]

New Parts

Got some shiney new parts today! New Overdrive and Transfer box cover Roamerdrive! Certainly looks well built I don’t think those splines will wear out any time soon (unlike other brands of overdrive!) Heystee Disc Brake conversion kit