Land Rover Rebuild – Day 8

Welding Day! Also got the front springs fitted. I did however run into a couple of issues – the new front shocks are not long enough, and neither was the front propshaft. So I bought a propshaft spacer, and will fit the old shocks once the engine is fitted. I’ll fit the new shocks once […]

Land Rover Rebuild – Day 7

Got the new steering bars fitted last night, and moved the Landy outside the garage (easier to get to the tools!) Today has been fitting the new springs on the rear (Yes, it took all day in between the rain, and fighting seized bolts!) New Steering Bars. Old spring removed Old and New – It’s […]

Land Rover Rebuild – Day 6

Spent the day cutting out all of the rusted metal on the front end, ready to weld up. As I will  be using the box section from a civilian land rover, I needed to reuse the spring hanger plates. I left the inner plate attached to the chassis & front cross member, as this makes […]

Land Rover Rebuild – Day 5

Today is the day that I started putting bits back together. Managed to get the chassis cleaned up a little with the pressure washer, put in all of the breather lines for the gearbox, transfer box and diffs, then installed the gearbox. Breather Line to front axle   Breather pipes for gearbox and transfer box […]

Land Rover Rebuild – Day 4

Most of today was spent in the Garage, building up the gearbox and starting on the engine. Started with the gearbox, and specifically the reverse gear, with the issues I’ave been having with it jumping out of gear. With the gear fitted on it’s shaft, and the selector fitted, I could see that the gear […]

Land Rover Rebuild – Day 3

And so day 3 begins… Mostly carrying on from where I finished yesterday. The engine block has now been removed, was fairly easy to lift out once I’d remembered to remove the earth cable. I did end up removing the starter motor, disconnecting the gearbox, and the sliding the block forward so I could remove […]

Land Rover Rebuild – Day 2

So Day 2 has basically been stripping the front end completely. Wings off, radiator panel and radiator out, fluids drained and the engine stripped to pull out piece by piece (I don’t have an engine crane). While dismantling the engine, I found a few things of concern – mainly two damaged pistons where lumps of […]

Land Rover Rebuild – Day 1

So the time has come to do a large amount of work on the Land Rover. Mainly to get through an MOT, and so I can go on a road trip to the Netherlands. The list of things that need attention: Clean & Waxoyl Chassis, along with welding a few holes aroud the front crossmember […]