And so day 3 begins… Mostly carrying on from where I finished yesterday. The engine block has now been removed, was fairly easy to lift out once I’d remembered to remove the earth cable. I did end up removing the starter motor, disconnecting the gearbox, and the sliding the block forward so I could remove the clutch and flywheel. This was to make it a manageable weight to lift out. I think when I put the new engine in, I’ll fit the block with just the crank, flywheel and clutch, then build the rest of it in situ.
I also removed the main gearbox to investigate the issues I’ve been having there (jumping out of first and reverse, noisy in second). Here I was hoping to dismantle the box in situ, so wouldn’t need to remove the whole casing. Unfortunately this wasn’t the case, I ended up stripping it and carrying all the bits to the garage, so I’ll rebuild it up in there, then bolt it back in in one go. (I forgot that the gearbox and transfer box need to be split to remove the reverse idler shaft)
I also managed to get a chance to look at the state of the front spring hanger. However once I’d cut a couple of panels off, it was a bit far gone to have a couple of bits of sheet welded in. So I’ve ordered a replacement spring hanger. These are only avaliable in civilian, so I will have to remove and reuse the spring hanger plates off the old one (fortunately these bits look OK!)
Engine Split from the gearbox
And from above. Notice how black the inside of the engine is…
And engine has been removed! And at this point, I took a break as it started raining…
Not particularly clear, however there wasn’t much metal left on the inside. Chassis was cracked on both sides and the bottom where the metal was so thin.



