Victron Charger Repair

So I was browsing eBay before Christmas for a battery charger (as I’ll need one for the tiny house as a backup). Usually decent chargers are £600 or more, but I came across a listing for one for £200, with a “faulty switch board” A few questions later, to find out the history, and the […]

Battery Pack Rebuild

After numerous broken wires on a 12V 22Ah Lipo Battery pack, I decided to make a proper case for it (it was in shrink wrap before, with flying leads). I made some aluminium top and bottom plates, with the rest 3D Printed. There are two main output sockets, room for another charger socket (which I […]

RGB LED Garden Lights

More than a year after I started the project, I’ve finally finished a set of waterproof RGB LED lights for my brothers garden. They can run on either 12V or 24V power, and draw about 30W with the LEDs set to white at full brightness, and about 10W running the rainbow cycle pattern. I’m rather […]

Raspberry Pi Projects

Some time ago I started building a add-on board for a Raspberry Pi Zero, at the time I never got the ethernet working, then other things came along, and I haven’t had chance to finish it until now… It didn’t take to long to work out why the ethernet wasn’t working, it turns out I […]

Making an LED light from an old LCD Monitor

For this small project, I used a Youtube video from DIY Perks as a guide – this one to be exact – https://www.youtube.com/watch?v=8JrqH2oOTK4 I used an old 19″ Monitor being thrown out at work, and used this LED strip from ebay: https://rover.ebay.com/rover/1/710-53481-19255-0/1?icep_id=114&ipn=icep&toolid=20004&campid=5338568634&mpre=https%3A%2F%2Fwww.ebay.co.uk%2Fitm%2F323888256457 Other than that, it was a very straight forward build. I did use […]

Sine Wave Inverter Build

About 3 years ago I bought a 350W Sine Wave Inverter, just he circuit board, without any case, heatsinks or fan. I fitted heatsinks to it and used it like that for a while, but I have finally got around to finishing it off! I drew up the case pieces, and got them laser cut […]

Electrical Fuse Box Build

I’m building a fusebox for the Land Rover, to contain all the fuses, relays and other electronics for both systems (the main car electrics, and the house battery system). With a minor amount of work, the design could easily be adapted to a off-grid solar system or similar. I’ve designed most of the box in […]

Land Rover Relay Box

I’ve finally finished building this relay box – as part of the much larger project of rewiring the whole landy! This will be mounted on one of the radio boxes, so it’s near to the alternator, and the high current loads it will be supplying (headlights, spotlights, radiator fan and air compressor). I’ve done a […]

CAD Modelling time

Tonight I’ve spent the evening updating the CAD model I started for the land rover, mainly so I can plan out the next storage units, making sure they are how I want them without wasting any wood. (The next things to build are the storage units on the passenger side)