Raspberry Pi Power

And my PCBs from China have arrived! So I’ve got to work assembling the first board, to make sure everything works. So far, there have been a couple of issues: The green LED on the ethernet connector was backwards. Fixed this time by dismantling the connector and turning the LED the other way round. Ethernet […]

Free Batteries

I picked up a huge batch of batteries a short while ago. They are made from non-rechargeable Lithium Thionyl Chloride cells, at 3.7V & 17.5Ah per cell, assembled into sticks of three, then into larger packs. What will I use them for, you ask? They have a very long shelf life, and very low self […]

New Solar MPPT Charge controller

I bought one of the cheap Tracer 4210AN MPPT Charge controllers for a project I have lined up. So far, it’s not bad for the price I’ve wired it temporarily on 4 of the 120W panels I have on my system, and I’ll keep an eye on it. So far, I’m getting 30% extra power […]

LED Floodlights for Off Grid use

I needed some decent floodlights for when I’m working on the car… But everything you find online is for mains powered stuff, usually with halogen bulbs, similar to the sort of thing used on building sites. Not good enough for me. I already had a few light-duty tripods, normally used for photography. I bought some […]

Preamplifier Repair and Modification, Part 1

So my old Audio preamplifier I built over 10 years ago needed a bit of work. I’ve been having issues with noise on some input sources, usually high frequency whining & humming. I’ve been trying to isolate earth loops for a while, but with mixed success. As a last ditch attempt, I decided to convert […]

Another Circuit Board

This time, I’m designing a ‘hat’ for a raspberry Pi Zero. it includes two different wide input power supply (so I can run it directly on a 12V or 24V battery), an ENC28J60 Ethernet controller to add networking, RS232 level shifter for the console, an I2C temperature sensor and several transistor drivers for GPIO. I’ve […]

Mutlipurpose LED Driver

So I’ve spent the last few days designing an LED driver, mostly for use within my solar system. The requirements are Input range of 9-32V (To run on either a 12V or 24V system) Use a switch mode converter to step down. Drive a RGB LED using a WS2811 LED Driver Or drive a single […]