And my PCBs from China have arrived! So I’ve got to work assembling the first board, to make sure everything works. So far, there have been a couple of issues:

  • The green LED on the ethernet connector was backwards. Fixed this time by dismantling the connector and turning the LED the other way round.
  • Ethernet doesn’t seem to be functioning properly. Controller is detected by the Pi, and a network connection is established, juding by the flashing LEDs, but no IP address… Not sure if this is an issue with the hardware or software – I need to investigate further.
  • The 5V power supply isn’t really man enough for the job. Turns out even a Pi zero draws more than 300mA when you add an ethernet jack.

Still to test is the real time clock (on order), and the I2C temperature sensor (Need internet access to install the I2C utilities), as well as test the isolated DC-DC option, and the cable ethernet. I also haven’t added the transistors for the output drivers, but I won’t until I’ve sorted everything else, I don’t want to add even more load to the inadequate PSU!

At least I have some photos of the progress so far!

Pi zero, an assembled board and a bare one
Top view – note the big blue capacitor, required to smooth out the inadequate power supply
Bottom side

Leave a Reply

Your email address will not be published. Required fields are marked *