I’ve needed to replace the number plate light on the back of the land rover for some time – one of the previous owners must have reversed the landy into a wall, and broken the light. (Not that there is a number plate at the top anymore, one has been bodged onto the bottom)

But I didn’t want to use the standard bulb for this, I’d rather have LEDs. Except that there isn’t anything avaliable to shine sideways… Not a problem, that’s why I have a 3D Printer!

I used 3x 5mm LEDs, running at 20mA. Still more than bright enough, and probably brighter than the original bulb. I’ve yet to wire it in, I’ll do that when I make the new wiring looms.

The light fitting, the original bulb, and the LED conversion, with attached cable
All assembled! I won’t use the rubber boot over the base, as the back of the light is in the living space.
And fitted. I used a piece of neoprene foam rubber to create a seal to the body.

Leave a Reply

Your email address will not be published. Required fields are marked *