A week ago I finally decided to pull the heads off of the land rover engine, to see what if I could find out why I was having issues with loosing water & overheating. This is what I found:

the head gaskets were in a bad way
This is the one where the water was leaking

The head gaskets had broken up somewhat, the worst part being at the back of cylinder No 8, which also had signs of rust on the exhaust valve. I’m not too sure why this has happened, unless I hadn’t been torquing the heads often enough when I first built the engine.

Still, I reground all the valves in, and gave the heads, inlet manifold & rocker covers a wire brushing & a lick of paint, and put it all back together.

And the finished result:

Leave a Reply

Your email address will not be published. Required fields are marked *