So the time has come to do a large amount of work on the Land Rover. Mainly to get through an MOT, and so I can go on a road trip to the Netherlands. The list of things that need attention:

  • Clean & Waxoyl Chassis, along with welding a few holes aroud the front crossmember area.
  • Fitting new breather lines on the diffs, gearbox and transfer box.
  • Rebuilding the rear axle, including changing to a 3.54 ratio diff, and rebuilding the brakes.
  • Replace the front diff, again with a 3.54 ratio unit
  • New Shocks and springs. Current springs are past their best, so will be upgraded to heavy duty parabolic springs.
  • Front Brakes are in poor shape. I will be going with a disc brake conversion, as I can regularly overheat the standard drums down long hills!
  • Replace the steering bars. A couple of the ball joints are dry and full of dirt, and have siezed onto the bars, so easier to replace the whole lot.
  • Replace the radiator. Fins are disintegrating on the current one, and I have a spare in the garage, so might as well change it
  • Rebuild / replace the engine. Current engine burns oil, and seems only to run on about 6 1/2 cylinders.
  • Investigate the gearbox issues – Currently jumps out of reverse, and first on overrun. And is a bit noisy on second.
  • Fitting an overdrive. Will be ideal to keep the revs down on long distance motorway driving

Before I start…

First thing to do was to identify a suitable replacement engine block from the spares I have. One turned out to be a 3.9, with rusty bores, so was of no use. Another block had been cleaned up by a previous owner, and has virtually no wear (under half a thou!). With a hone and a new set of pistons and rings this will be ideal. Crank, bearings, con rods and camshaft will be taken from the 3.9 engine, as this has done about 80 miles since being rebuilt. Shame about the condition of the bores really…

Engine bits everywhere!

The ‘New’ Block

Minor surface rust can be seen on the bores, but this will be gone after honing.

Nearly new camshaft

Pair of heads. Not sure if I’ll use these, or if I have a better pair in the garage somewhere…

Leave a Reply

Your email address will not be published. Required fields are marked *