As I’ve been driving around without a heater in the Land Rover (It wouldn’t fit after I did the Rover V8 Conversion), now is the time to get some heating again.

I will be using the original heater, plus a second kitcar type heater inside, with new 3D Printed ducting and some rather powerful fans, plus some electronics to control the fan speeds. Again, photos show a thousand words…

Part 2 coming soon!

The Original Heater after a coat of paint

High Power Fan, as used in Dell (and other) servers. 3.9 Amps at 12V should be enough!

New air intake assembly, to replace the original series 3 air intake on the side of the wing.

 

Complete Air intake piping, plus the two adaptor pieces required to move the heater, to clear the air filter elbows on the engine

Heater and Ducting Installed

Fan Assembly can just about be seen

And the view from the outside

Leave a Reply

Your email address will not be published. Required fields are marked *