One thing I have on my 3D Printer (And I’m sure most others are the same) are cooling fan for the electronics and extruder body, to keep everything running cool. However currently on my printer, they are wired to the power, so if the printer is on, so are the fans. Wouldn’t it be nice to have them come on only when needed?

Marlin Firmware already supports both a Controller Fan and Extruder Cooling Fans, so I will enable these in the firmware. As I have a spare slot for a stepper motor driver, I shall make an adaptor to fit here with a couple of MOSFETs to drive the fans.  I had a rummage in the random transistors box, and found some 2SK462 2A MOSFETs, ideal for the task.

The Controller cooling fan is connected to Extruder 1 enable, (D30) and the extruder cooling fan is connected to the Extruder 1 Direction (D34). This leaves the four servo outputs spare for RGB status lights, and case lighting.

Some things I still wish to add to the printer

  • Case Lighting
  • Raspberry Pi running Octopi
  • Control of the hotend cooling fan
  • RGB LED Status Light
  • Custom PCB (Uniting the Arduino, Ramps + Stepper drives, and all my addons (including a Pi zero, mounted on a header on top of the mainboard)

Circuit Diagram, plus the MOSFETs I have used

The completed fan driver board

And plugged into the spare space for a stepper motor driver

Leave a Reply

Your email address will not be published. Required fields are marked *