Land Rover Rebuild – Day 10

Got a bit further with the engine rebuild today. Pistons and camshaft fitted, along with fitting the overdrive and new transfer box cover plate. Engine now on its mounts All the pistons fitted And from another angle Transfer box cover plate and overdrive Overdrive Fitted! With the lever fitted (Now there are four gearsticks!)

Land Rover Rebuild – Day 9

Managed to fit the crank, flywheel and engine block today. Had to fit the flywheel to the crank, get that lined up on the gearbox input shaft, then lowered the block (with the bearing shells fitted) onto the crank, then bolted up the main bearings. (Without a crane, I couldn’t build the engine, then fit […]

New Parts

Got some shiney new parts today! New Overdrive and Transfer box cover Roamerdrive! Certainly looks well built I don’t think those splines will wear out any time soon (unlike other brands of overdrive!) Heystee Disc Brake conversion kit

Land Rover Rebuild – Day 8

Welding Day! Also got the front springs fitted. I did however run into a couple of issues – the new front shocks are not long enough, and neither was the front propshaft. So I bought a propshaft spacer, and will fit the old shocks once the engine is fitted. I’ll fit the new shocks once […]

Land Rover Rebuild – Day 7

Got the new steering bars fitted last night, and moved the Landy outside the garage (easier to get to the tools!) Today has been fitting the new springs on the rear (Yes, it took all day in between the rain, and fighting seized bolts!) New Steering Bars. Old spring removed Old and New – It’s […]

Land Rover Rebuild – Day 6

Spent the day cutting out all of the rusted metal on the front end, ready to weld up. As I will  be using the box section from a civilian land rover, I needed to reuse the spring hanger plates. I left the inner plate attached to the chassis & front cross member, as this makes […]

Land Rover Rebuild – Day 5

Today is the day that I started putting bits back together. Managed to get the chassis cleaned up a little with the pressure washer, put in all of the breather lines for the gearbox, transfer box and diffs, then installed the gearbox. Breather Line to front axle   Breather pipes for gearbox and transfer box […]

Land Rover Rebuild – Day 4

Most of today was spent in the Garage, building up the gearbox and starting on the engine. Started with the gearbox, and specifically the reverse gear, with the issues I’ave been having with it jumping out of gear. With the gear fitted on it’s shaft, and the selector fitted, I could see that the gear […]

Land Rover Rebuild – Day 3

And so day 3 begins… Mostly carrying on from where I finished yesterday. The engine block has now been removed, was fairly easy to lift out once I’d remembered to remove the earth cable. I did end up removing the starter motor, disconnecting the gearbox, and the sliding the block forward so I could remove […]