So I thought I’d spend the evening taking the rear diff out of the landy, so I can change to a 3.54 ratio. Had no issues removing the easy bits, but had no luck getting the differential out of the casing. I even made a diff spreader, but that ended up looking a bit banana-shaped… So I had to put it all back together again. At least I managed to change the pinion seal… so it wasn’t a complete waste of an evening!

Started Work…

Got this far, no issues…

My Homemade Diff spreader – not man enough, unfortunately.

Leave a Reply

Your email address will not be published. Required fields are marked *