I’ve decided to add another 3 80W solar panels to the roof of the Land Rover, after being caught out by a low battery a week ago (running the fridge and lights for 3 days in cloudy weather). I already had the solar panels in the loft, so just had to make new mounts & rewire them.

The outer brackets are 3D Printed, and allow each pair of panels to be tilted up if necessary (to get more sun!), and the panels are bolted to 25×25 aluminium box section. Panels are wired in parallel to a single 20A charge controller for the moment, with the wiring fed through a junction box via a waterproof connector. Each pair of panels have their own wires, so I can feed them to independent charge controllers in future.

There is room to fit another two panels, should I need more than 320W!

3D Printed Bracket

Each bracket is bolted horizontally, to allow tilting the panels up. Note the 3D Printed End cap, which also acts as a spacer to prevent the box section from crushing.

The Panels all bolted to the roof. Should provide enough power for the moment!

Leave a Reply

Your email address will not be published. Required fields are marked *