I’m Back!

Hello Everyone! I’m back! I’ve been neglecting the blog for some time, but now I’ll be updating as often as I can. I’m also going to post stuff on a much wider range of subjects, to include: Electronics Projects, including arduino code, PCB designs and such 3D Printing and CAD designs Modelling (I have several […]

Starting on the camper conversion

This weekend I have started stripping the interior so I can start on the camper conversion. Started with removal of the bulkhead behind the seats, which will then make room to allow a bed to be folded over the front seats. I’ve ordered some aluminium box section to strengthen the body where the bulkhead used […]

Land Rover Rebuild – Day 12

Unfortunately I’ve been too carried away to take photos, however the Landy is now running again! Did have a couple of minor issues, like a leaking water pump (just as well I bought a spare!) Now time to do some miles and run the engine in (I’m off to the Netherlands for a long weekend […]

Land Rover Rebuild – Day 10

Got a bit further with the engine rebuild today. Pistons and camshaft fitted, along with fitting the overdrive and new transfer box cover plate. Engine now on its mounts All the pistons fitted And from another angle Transfer box cover plate and overdrive Overdrive Fitted! With the lever fitted (Now there are four gearsticks!)

Land Rover Rebuild – Day 9

Managed to fit the crank, flywheel and engine block today. Had to fit the flywheel to the crank, get that lined up on the gearbox input shaft, then lowered the block (with the bearing shells fitted) onto the crank, then bolted up the main bearings. (Without a crane, I couldn’t build the engine, then fit […]