Last night I started fitting the LPG kit, and as it requires a hot water feed, I finally have to do something about the heater in the Land Rover (as the LPG vaporiser uses the heater circuit).

I’d ordered the parts to do it ages ago, but like many things, I never found the time to do it. I ended up doing most of the plumbing using 15mm copper pipe and fittings, as it was cheaper and easier to do – the silicone hose parts aren’t cheap, and there’s no way they would fit in the small amount of space at the back of the engine, under the air filter.

I’m still not finished, I need to turn up some adaptors for the second heater inside (which has 10mm hose fittings), and finish of the length of pipe that runs along the wing to the vapouriser

It was tight getting all the pipework in here!
An overall view. The solenoid valve will be used to turn the heaters on and off.
The LPG vapouriser, and solenoid valve underneath (hidden by the outlet pipe)

Leave a Reply

Your email address will not be published. Required fields are marked *