So it’s time for a PC rebuild again… Only minor changes to the hardware side, but a full rebuild into a new case. And I’m having to do this as I won’t have room for a 19″ rack in the tiny house!

So I bought a Fractal Define 7 case, and a new power supply, and transplanted the hardware into the new case.

The PC in it’s old config

The old PC had been running without a top lid for some time, as the graphics card I was given is a full height card, and the case was built to take low-profile cards only… The radiators and fans were mounted in the rear of my 19″ cabinet. I also need to upgrade the power supply, the current one is a 450W supply, and under full load, it’s a bit too close to the limit for comfort (300W GPU and 125W Processor, plus peripherals)

The new case

I picked up a damaged case on ebay for half the usual amount (there was 1 small scratch, and I couldn’t even find it!) I also found a refurbished 850W Titanium power supply for a substantially less than a new one.

Front view of the finished build

It was a fairly simple job to transfer all the hardware, although I had to completely re-do the water cooling plumbing. There is a 360mm radiator in the top, and a 280mm radiator in the front.

I also added a pair of 3TB hard drives in the basement section, which I will use as an additional local copy of all my photos and video footage.

The back view
And the finished PC

With the case I’ve chosen, it’s a very clean look, with none of that RGB nonsense! Plain, simple and understated!

This will keep me going for now, however I’m already looking at future upgrades.
– A motherboard upgrade, as I need more PCIe slots for future expansion (such as a video capture card, and more Nvme storage), plus 10 gig networking would be nice
– A graphics card upgrade – the R9 Fury is no longer supported by AMD, and not getting driver updates. It’s also not very power efficient!

Leave a Reply

Your email address will not be published. Required fields are marked *