Another job I’ve been meaning to finish off for a while – adding a few upgrades to my PC. I bought a better graphics card some time ago, a couple of solid state drives, and a couple of hard drives.
Once again, I put my 3D printer to good use, making brackets to hold all of the drives, and a fan shroud to direct air over the graphics card heatsink.
I replaced the heatsink and fan on the graphics card as the original one was rather noisy… I’d already done the same on the previous card, however I had to make a couple of spacers to clear some of the other components.


I’ll list the full specs down below for those interested. Even with the upgrades it’s still almost silent, and still draws less power than anything else of a similar spec as I’ve tweaked a lot of settings to optimize power efficiency, rather than chasing performance.
The full specs:
- i7 3770 quad core processor (slightly undervolted)
- 32GB DDR3 1600MHz memory (again undervolted)
- Asus P8Z77 Motherboard
- GTX1050 ti Low profile graphics card
- 120GB Sandisk Extreme SSD (Boot Drive)
- 480GB Sandisk Extreme SSD
- 2x 240GB Samsung 850 Evo SSDs
- 2x Western Digital Black 1TB Hard Drives
- Firewire card (for my Audio gear)
- 160W Picopsu + 200W Power brick
I’ve pretty much hit the limits of this platform now – I’ll leave this build as it is and build something else in a year or two… The only thing I may do is replace the power supply with one that will run on 12 or 24V direct from the solar system batteries – which will remove the power losses in the power supply brick and inverter.